can you tint dtm paint?

DTM coatings may ease the application process, but there are still a few critical steps to keep in mind when coating a surface.

As a two-in-one coating, surface preparation is significantly reduced because applicators get to skip the primer application step. However, for the full effect of DTM and an aesthetically pleasing result, it is important to make sure that the substrate receiving the coating is prepped correctly.

The surface must be cleaned before application to ensure adequate adhesion. This cleaning would include getting rid of foreign materials like oil, grease, dirt, or loose rust. Several strategies may be employed to achieve this cleanliness.

A wire brush can be used to remove any rust or flaking paint from the substrate’s surface. The remaining dirt or foreign material can be removed simply by wiping it down with a damp cloth. Meanwhile, acetone can be used to remove substances like grease or oil.

Before beginning the application process, it is important to mix the paint.

With a freshly cleaned surface and thoroughly mixed paint, the coating is ready to be applied. Most DTMs are applied by brush, roller, or spray. However, the spray method is the recommended method of application because it is easier to use on metal. Tizbi Technologies recommends using a 0.015” sprayer tip and adjusting the pressure to 1500 psi.

It is important to keep track of the recommended application rate and thickness of the used product. Thickness can significantly affect the resulting coating. However, keep in mind that the actual rates can vary based on the application method and the substrate in use.

Drying time can be influenced by factors like coat thickness, temperature, humidity, and ventilation. When finished, tools and other materials can be easily cleaned with water.

Overall, the preparation, application, and resulting clean up of a DTM paint is much easier than alternative coating methods. Collectively, the use of DTM saves the applicator a lot of resources and time.

Buzzweld DTM is a specially formulated Glass Flake Impregnated single application (when applied neat through airless spray or similar method) high build coating based on a fast drying high solid alkyd resin.

DTM has excellent chip resistance, corrosion and seawater resistance with benefits including;-

TINTABLE

Suitability

Compatible with most fully cured paint systems, DTM is suitable for protecting a range of prepared steel surfaces from chassis and underbody to axles, bodywork and more.

Preparation

Application Methods.

Aerosol > typically 4 coats.  Check film is minimum 100 microns DFT, > 180 microns for higher profile such as aggressive blasting.

Schultz tin spray- Applied neat 60> 75PSI typically

Tinned-

Use tip 0.38-0.53 mm, 50-65° angle and 2000-2300 psi pressure

Properties

Semi Gloss finish

5m2 theoretical coverage

Pro's

Cost effective protection of steel surfaces

Variety of colours and application methods available.

Con's

Corrosion needs to be remedied prior to application.

Quantities estimate

Large 4x4 chassis (110 size) 5L or 24 cans

Winch Bumper 1L

Axle 1L

Nas Step 1L

Half Chassis/ small 4x4 2.5L

Small vehicle underbody 2.5L

Large 4x4 underbody 5L

Buzzweld DTM Direct To Metal Satin Paint