Petra Owe

Set posts

While installing your wood posts, make sure you mark where the gate opening will be. Your gate posts will have a different distance compared to that of other fence posts. The typical gate opening is 36 inches.  Add to this a 1 1/2 inch (3/4 inch each) combined gap for gate hinges and the gate latch, and you will have a total distance of 37 1/2 inch between your gate posts.  This measurement is intended for self-closing hinges. There is no need to provide a gap for hinge installation if you will be using the regular hinge types.

Attach rails

After securing your fence posts, fix your fence rails onto them. Do not cut the rails at hinge post and latch post. These rails will serve as the primary frame for your wood gate.

Insert diagonal braces

To add stability and strength to your wood gate, insert diagonal braces on the railings in between your latch and hinge posts. Place these braces leaving a 4-inch clearance to the posts.  This clearance will serve as space for the latch and hinge installations.

Cut rails on gate hinge side

When cutting the rails on the hinge side, be sure to cut the rail only halfway through if you will be using a regular hinge. If you’re using self-closing hinges, cut the rails on the hinge side but be sure to provide support for your gate weight and the force of fixing the fence pickets.

Nail pickets in place

In fixing the nail pickets allow a 3/4 inch gap on latch side. On the hinge side also allow a 3/4 inch gap if you will be using self-closing hinges. No allowance is needed on the hinge side if you will be using regular hinge types.

Install hinges

Install hinges along the railings of the fence.  Installing a hinge on the top, middle, and bottom rail is advisable for regular hinge types.  For stronger hinge types, top and bottom hinges may be sufficient.  For regular hinge types, cut the center back of rails on hinge side after installation.

Cut rails on latch side and install gate latch

Cut the rails on latch side and install the latch. Make sure that proper support is provided to the gate while installing the latch.  Ensure appropriate latch installation by using reliable installation guides.

Insert gate stopper

To prevent the gate from opening more than the desired angle and causing unwanted damage on the hinges and the gate, insert a 2 inch by 4 inch gate stopper or “Back Stop” with a setback of 1/2 inch from the pickets.

EziLux - Polyshield Shutters

Address: 5/86 Kingston Rd, Underwood QLD 4119, Australia